Descripción
UG 25+
Microprocessor controlled governor offers enhanced control capabilities, such as start fuel and boost limiting schemes.
UG-8 GOVERNORS
The UG-5.7/8/10 governor is a mechanical-hydraulic governor for controlling diesel, gas, or dual fuel engines, or steam turbines. These governors (generally known as “UG-8”) are available in either a UG dial or UG lever configuration. UG dial governors are particularly suited for constant speed applications. UG lever governors are widely used for variable speed control.
UG-8PL
The UG-8PL is a compensated, isochronous governor for use with diesel, gas, and dual-fuel engines or steam and industrial gas turbines driving pumps, compressors, alternators, generators, etc. Either direct or reverse pneumatic speed setting mechanisms are commonly used with this governor.
UG-40 GOVERNORS
UG-40 governors are used for speed or load control of larger dual fuel, diesel, or gas engines or steam turbines, with governor drive speeds of 350 to 1050 or 550 to 1300 rpm. Governors with lever speed setting are primarily used for propulsion engines. Dial or motor speed setting is primarily used for power generation installations.
UG MAS GOVERNORS
The UG MAS (milliamp speed setting) controls the speed or power of prime movers used for propulsion, locomotives, pumps, and compressors. The pressure-compensated, hydraulic governor accepts a standard 4-20 mA electrical current signal to set the speed of the governor. An internal pump, relief valve, and accumulator system maintain the governor operating pressure. A self-contained sump stores the oil and reduces the possibility of contamination from outside sources.
